深圳市博納德精密儀器有限公司
深圳市博納德精密儀器有限公司
簡單介紹： IEC61032 The Standard Test Finger ProbeIEC61032 The Standard Test Finger Probe / The Standard Test Knurled Finger Probe / Test Probe B / IP2X Protection Grad......
Article NO.: BND-B
specification:
The Standard Test Finger Probe / The Standard Test Knurled Finger Probe / Test Probe B / IP2X Protection Grade Probe
Technical Parameters:
1, Knurled Finger Diameter:12mm
2, Knurled Finger Length :80mm
3, Baffle Plate Diameter :50mm
4, Baffle Plate Length : 100mm
5, According to :IEC60065, IEC 60335-1, IEC 60529, IEC60884-1, IEC60950, IEC61032, IEC69745-1
Application:
1, The joint part of The Standard Test Knurled Finger Probe can't touch the live parts or close to the dangerous parts, and 50 mm to 20 mm baffle plate cannot enter.
2, In the prevent electric shock test, wires , power devices, and lighting devices are needed.
3Both joints shall permit movement in the same plane and the same direction through an angle of 90° with a 0° to +10° tolerance
This probe is intended to verify the basic protection against access to hazardous parts. It is also used to verify the protection against access with a finger.
Tolerance on dimensions when no specific tolerance is given:
– on angles: 0
?10°
– on linear dimensions: up to 25 mm: 0
? 0,05 mm; over 25 mm: ± 0,2 mm.
Note : The Test Probe is made of precision stainless steel products, take and put down slightly when using, and pay attention to maintenance
IEC 61032 Figure 2 – Test probe B
IEC61032 The Standard Test Finger Probe
IEC61032 The Standard Test Finger Probe
IEC61032 The Standard Test Finger Probe
IEC61032 The Standard Test Finger Probe
您感興趣的產品PRODUCTS YOU ARE INTERESTED IN
儀表網 設計制作，未經允許翻錄必究 .? ? ?
請輸入賬號
請輸入密碼
請輸驗證碼
