江蘇春晨電纜有限公司：http://www.gd5688.cn/st82365/
適用于連續運行導體溫度為70度電機繞組引接線。JXF電機引接線
JXF電機引接線使用條件：
連續運行導體溫度為70度，允許彎曲半徑不小于電纜外徑的4倍，JXF電機引接線
JXF motor lead wire connection details:
JXF motor lead wire application: suitable for continuous operation of conductor temperature of 70 degree motor winding lead wire. JXF motor wiring conditions: continuous operation of conductor temperature is 70 degrees, 4 times JXF motor allowed bending radius of not less than the outer diameter of the cable wiring conductor uses 1 Parameters of tinned copper wire, which comply with the provisions of the table 1, 2 of the performance of the JB947-76 "rubber and plastic insulated wire and cable wire core" in the request copper conductor. 2 insulation rubber performance in line with the JB664-77 "wire and cable with rubber" standard. The insulation thickness is in the form of 1 and 2, which allows the deviation of -10%, and the thickness of the * * * is not less than the nominal value of 90%-0.1mm. 3 sheath rubber performance in line with the JB664-77 "wire and cable rubber", the thickness of the jacket in accordance with the table 2, 1, to allow the deviation of -20%, its * * * thin thickness of not less than 80% of the nominal value. 4 finished wires shall be subjected to OYYDDL0118-2003, specified AC 50Hz voltage endurance test. 5 finished wire guide wire core DC resistance at the temperature of 20 C should be in accordance with the provisions of Table 2, 1. 6 wires can withstand dipping test wire by 130 - 5 DEG C, 5 hours after the temperature, immersion temperature of 50 + 5 C 1032 paint for 30 minutes, remove the drain, and then by 130 - 5 DEG C, 48 hours after the wire winding temperature, * * * in the rod diameter provisions, wire sheath should I crack brittle and sticky phenomenon
